H.M.S. Communications, Inc.
ICOM LAND MOBILE REPEATERS
This information is taken directly off of the ICOM IC-RP1620
brochure.
IC-RP1620 SPECIFICATIONS
Remote control versatility
An advanced CPU design and logic circuit allow full remote control of the
following parameters:
- CTCSS encoder ON/OFF
- CTCSS decoder ON/OFF
- CTCSS encoder frequency setting
- CTCSS decoder frequency setting
- Local inhibit function ON/OFF
- Manual ID signal transmission
- ID signal transmission speed setting
- Time-out timer setting
- Hang-up timer setting
- Repeater-pausing time after time-out
- CPU resetting
- Fine tuning of the operation frequency
- 3 auxiliary control outputs
General
- Frequency Coverage:
- 136-150 MHz* (low band version)
- 150-174 MHz* (high band version)
- *Permitted frequency range differs according to countries. Consult
your local ICOM dealer.
- Mode:
- FM (16K0F3E)
- FM (8K50F3E) (narrow version)
- Initial tuning step: 5 or 12.5 kHz (selectable)
- Antenna impedance: 50 ohms (unbalanced)
- Power supply requirement: 117 V AC or 13.8 V DC ±15%
- AC power consumption: 160 VA
- Current drain (at 13.8 V DC):
- Transmit: 8.0 A
- Receive (squelched): 1.0 A
- Receive (maximum audio output): 1.2 A
- Usable Temperature Range: -10°C ~ +60°C
- Frequency stability: ±0.0001%
- Dimensions: 425(W) x 149(H) x 368(D) mm; 16.7(W) x 5.9(H) x 14.5(D) in
- Weight: 17 kg; 37.5 lbs.
Transmitter
- Output power: 25 W
- Modulation system: Variable reactance frequency modulation
- Maximum frequency deviation: ±5 kHz; ±2.5 kHz (narrow version)
- Spurious emissions: -70 dB
- Microphone impedance: 600 ohms
Receiver
- Receive system: Double-conversion superheterodyne
- Intermediate frequencies: 1st 21.8 MHz; 2nd 455 kHz
- Sensitivity: 0.5 µV for 12 dB SINAD
- Tight squelch sensitivity: 1.0 µV
- Adjacent channel selectivity: -70 dB; -60 dB (narrow version)
- Spurious rejection: -70 dB
- Audio output power: 1.7 W with an 8 ohms load
- Audio output impedance: 8 ohms
A duplexer is separately required when only one antenna is used for both
transmitting and receiving.
The ICOM logo is a registered trademark of
ICOM, Inc. All ICOM radios significantly exceed FCC regulations limiting
spurious emissions. All stated specifications are subject to change without
notice or obligation. | 
