| |
H.M.S. Communications, Inc.
GENERAL
- Frequency range
- IC-F30GT/GS: 136-174 MHz
- IC-F40GT/GS: 400-430 MHz; 440-480 MHz;
450-490 MHz (USA); 480-512 MHz (USA); 480-520 MHz (others)
- Number of channels: Max. 256 Ch/ 16 banks
- Type of emission:
- 16K0F3E (25/30
kHz)
- 8K50F3E (12.5/15 kHz)
- 14K0F3E (20kHz)
- Channel spacing:
- 30/15 kHz (25/12.5 kHz)
- 20/12.5 kHz
- Antenna impedance: 50 ohms
- Frequency error: ±2.5 ppm (EIA); ±1.5 kHz
(ETS)
- PLL channel step: 5 kHz, 6.25 kHz, 7.5 kHz
- Power supply requirement: 7.5 V DC (Icom
battery pack)
- Current drain (at 7.5 V DC; approx.):
- Transmit at 5 W: 1.7 A typ.
(IC-F30GT/GS)
- Transmit at 4 W: 1.7 A typ.
(IC-F40GT/GS)
- Receive at AF max: 300 mA
- Receive at stand-by: 95 mA
- Operating temperature range:
- -30°C to +60°C; -22°F to +140°F
(EIA)
- -25°C to +55°C (ETS)
- Dimensions (projections not included):
- 54(W) x 139(H) x 38(D) mm
- 2 1/8(W) x 5 15/32(H) x 1 1/2(D) in
- Weight (with BP-210): 420 g; 14.8 oz
TRANSMITTER
- Modulation system: Variable reactance
frequency modulation
- Output power (nominal):
- 5.0 W (IC-F30GT/GS)
- 4.0 W (IC-F40GT/GS)
- Max. freq. deviation: ±2.5 kHz, ±5 kHz, ±4
kHz
- Modulation limiting: 60-100%
- Audio harmonic distortion: 3% typ. (1
kHz/40% dev.)
- Spurious emissions:
- -73 dB (EIA)
- Less than 0.25 µW (ETS)
- Adjacent channel power:
- 60 dB (ETS; 12.5 kHz)
- 70 dB (ETS; 25/20 kHz)
- Residual modulation:
- 43 dB typ. (ETS;12.5 kHz)
- 45 dB typ. (ETS; 25/20 kHz)
- External MIC connector: 9-pin multi
connector / 2.2 kohm
RECEIVER
- Intermediate freq.:
- 1st:
- 31.65 MHz (IC-F30GT/GS)
- 47.25 MHz (IC-F40GT/GS)
- 2nd: 450 kHz
- Sensitivity:
- 0.25 µV typ. (at 12db SINAD)
- 0.63 µV typ. (at 20 dB SINAD) e.m.f.
- Squelch sensitivity: 0.25 µV (at threshold)
- Adjacent Ch. selectivity:
- 63 dB typ. (ETS; 12.5 kHz)
- 73 dB typ. (ETS; 25 kHz)
- Spurious response:
- Intermodulation:
- 74 dB typ. (EIA)
- 70 dB typ. (ETS)
- Hum and noise ratio:
- 40 dB typ. (EIA; 12.5 kHz)
- 43 dB typ. (EIA; 25/20 kHz)
- 43 dB typ. (ETS; 12.5 kHz)
- 45 dB typ. (ETS; 25/20 kHz)
- Audio output power: 0.5 W typ. at 5%
distortion with an 8 ohm load
- External speaker connector: 9-pin multi
connector /8 ohm
Measurements are made in accordance with
EIA-152/204D, TIA-603 or ETS 300-086. All stated specifications are typical and
subject to change without notice or obligation.
APPLICABLE MILITARY SPECIFICATIONS
Icom makes rugged products that meet MIL-STD
requirements and strict environmental standards as follows:
Standard |
MIL
810C |
MIL
810D |
MIL
810E |
Method |
Procedure |
Method |
Procedure |
Method |
Procedure |
Vibration |
514.2 |
X |
514.3 |
I |
514.4 |
I |
Shock |
516.2 |
I |
516.3 |
I |
516.4 |
I |
SUPPLIED ACCESSORIES
- Antenna
- Belt clip
- Battery pack
OPTIONS
Battery packs and case:
- BP-208 AA
battery case (Alkaline batteries not included)
- BP-209
NiCd battery pack 7.2 V / 1100 mAh
- BP-210
NiMH battery pack 7.2 V / 1650 mAh
Approximate output power and battery life (Tx
(HI): RX: standby=5:5:90)
Battery
Pack |
Output
Power |
Battery
Life (approx.) |
IC-F30GT/GS |
IC-F40GT/GS |
BP-208 |
1 W typ. |
1 W typ. |
- |
BP-209 |
5 W typ. |
4 W typ. |
6.5 hours |
BP-210 |
5 W typ. |
4 W typ. |
10 hours |
Battery chargers:
- BC-119 DESKTOP CHARGER: + AD-94
CHARGER ADAPTER For rapid charging of battery packs, BP-209 or BP-210. An AC
adapter is supplied with the charger. Charging time: 1.5 to 2 hrs.
- BC-121 MULTI-CHARGER: + AD-94 CHARGER
ADAPTER + BC124 AC ADAPTER For rapid charging up to 6 battery packs
simultaneously, BP-209 or BP-210. Six AD-94's are necessary. The BC-124
outputs 12 V DC and has 7 A capacity for the BC-121. Charging time: 1.5 to 2
hrs.
- BC-137 BATTERY CHARGER: Regularly
charges a battery pack, BP-209 or BP-210, with/without transceiver. The AC
adapter, BC-122 is additionally required.
Belt clips:
- MB-74 BELT CLIP: Alligator type.
Clips onto almost anything!
- MB-68 BELT CLIP: Same as supplied
with the unit.
Speaker-Microphones:
- EM-80: Durable, full sized microphone
with internal speaker.
- EM-89: Slim dimensions. Equipped with
an earphone jack and a transmitter indicator.
- AD-52 EARPHONE JACK ADAPTER:
Transforms 9-pin multi connector to 3.5 mm (1/8") earphone connector.
Internal units:
- UT-105 SmarTrunk II™ LOGIC BOARD:
Provides SmarTrunk II™ capabilities.
- UT-109 VOICE SCRAMBLER UNIT: Provides
operating security. Up to 32 scrambling codes are available. The scrambling
system is not compatible with the UT-110.
- UT-110 VOICE SCRAMBLER UNIT: Provides
higher operating security. Up to 1020 (255 codes x 4 groups) scrambling
codes are available. The scrambling system is not compatible with the
UT-109.
- UT-111 TRUNKING UNIT: Provides LTR®
trunking capabilities.
- UT-113 MAN DOWN UNIT: Automatically
sends an emergency signal when the transceiver is left in the horizontal
position.
Combination of available internal units:
Check mark indicates that units are available simultaneously.
(1) UT-113 is available in conventional mode.
(2) UT-105 and the UT-111 have to be installed in slot 1.
* Same optional types, such as UT-109 and UT-110, cannot be installed
simultaneously.
Antennas:
- FA-SC25V: VHF antenna for 136-155 MHz
- FA-SC55V: VHF antenna for 146-174 MHz
- FA-SC25U: UHF antenna for 440-470 MHz
- FA-SC72U: UHF antenna for 470-520 MHz
* This device has not been approved by the
Federal Communications Commission. This device may not be sold or leased, or
offered for sale or lease until approval from the FCC has been obtained.
The ICOM logo is a registered trademark of
ICOM, Inc. All ICOM radios significantly exceed FCC regulations limiting
spurious emissions. All stated specifications are subject to change without
notice or obligation.
* This device has not been approved by the
Federal Communications Commission. This device may not be sold or leased, or
offered for sale or lease until approval from the FCC has been obtained. |